Engineering Design NIDisk Guida Utente Scaricare il pdf (Pagina 8)

DartDisk User Guide

DartDisk does not require SIGNAL in order to operate - it can be installed on any Windows

95/98/2000/XP computer for stand-alone data acquisition.

For technical specifications on the Dart card, see the SIGNAL for Notebooks User Guide,

available from Engineering Design.

2. Installation

To install DartDisk, perform these steps in the following order:

1. Install the Dart system driver and Dart card.

2. Install the DartDisk software.

Install the Dart System Driver and Dart Card

Instructions for installing the Dart system driver and Dart card are provided in Appendix C of

the SIGNAL Reference Guide.

The Dart card uses different system drivers for Windows 95/98 vs. Windows 2000/XP.

Be sure to follow the instructions in that section for your operating system.

Install DartDisk

After installing the Dart system driver and Dart card, follow these steps to install DartDisk.

1. Launch the setup file dartdisk_xxx_setup.exe (where xxx is the version number) by

double-clicking on the filename in Windows Explorer. If you received a zip file,

extract dartdisk_xxx_setup.exe from the zip file, then launch it.

2. Follow the installation prompts.

3. Install DartDisk in the same directory as SIGNAL. The default SIGNAL program

directory is c:\Program Files\Engineering Design\Signal 4.0.

Enable SIGNAL Security Key

DartDisk requires a SIGNAL security key which has been licensed for DartDisk. If DartDisk

reports a non-licensed security key, contact Engineering Design, and the key can be enabled

by email.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Nessun commento

Engineering Design NIDisk Guida Utente Pagina 8